51 Display illumination
51
Press the "LAP/RE." button again for approx. 5 seconds to
leave the energy saving operation mode, the display will be
switched on again.
9 Display illumination
By pressing the "LIGHT" button the display is illuminated for
approx. 5 seconds.
Permanent illumination of the display is also possible. In order
to activate the "night mode", press and hold the "LIGHT"
button for approx. 2 seconds. Press and hold the “LIGHT”
button again for approx. 2 seconds to leave the night mode.
The display lighting will disappear. If the Ski watch does not
have GPS reception, the night mode is automatically switched
off after approx. 10 minutes.
Please note more energy is consumed for the display
illumination, whereby the battery will lose its charge faster.
10 Battery change chest strap
Open the battery compartment lid with a coin, by turning it
anti clockwise. Remove the old battery and insert a new 3 V
battery type CR2032. You must ensure that the plus pole (+)
shows at the top. Place the battery compartment lid back on
and close it again, by turning clockwise. Ensure that the lid is
tightly closed so that no moisture can enter the chest strap.
To Next Page
Loading...
