Inserting the display module
− Push the display module
2
into the band
1
or the clip
5
so that it is secure and
cannot fall out.
You have successfully assembled the wristband and can now use it.
Putting on the wristband/clip
• We recommend that you do not wear the wristband on your dominant hand.
• Your pulse cannot be measured if the display module is used in the clip.
− Put the desired band
1
with the display module
2
around your wrist (ideally behind
your wrist bone) and fasten the band. The band should not be fitted too tightly, but also
not too loosely around your wrist. It must not cause you any pain, but it should be secure
enough so as to prevent loss.
To Next Page
Loading...