Safety
10
− Only run the saw up to the work piece once it has been switched on.
− Never process material containing asbestos. Use a protective mask and
dust extractor for other fibrous material.
− Do not slow down the saw blade by applying side pressure.
− Use clamping devices to secure the work piece and prevent slippage.
− During operation, always guide the saw with both hands and assume a
stable posture.
− Always route the mains cable away from the working space.
− Do not expose the saw to moisture. It must not get damp and must not be
operated in a damp environment.
− Wear a protective breathing mask and protective goggles when performing
dusty work. Do not smoke when performing dusty work and avoid open
fire.
− Wear protective gloves when handling saw blades and rough materials to
cut injuries.
− Wear ear protection when performing work.
− Do not leave any tool keys inserted.
Supplementary safety instructions
WARNING!
Risk of electric shock!
A faulty electrical installation or excessive mains voltage may result in an electric
shock.
− Only connect the product if the mains voltage of the socket corresponds to
the rating plate specification.
− Only connect the product to an easily accessible socket so that you can
quickly disconnect it from the mains supply in case of a failure.
− Never touch the product or the mains plug with damp hands.
− Lay the power cable so that it does not pose a tripping hazard.
− Do not kink the mains cord and do not lay it over sharp edges.
− Do not make any modifications or improper repairs to the product. These
may impair the operating safety of the product.
− All repair work must be carried out by trained personnel.
To Next Page
Loading...
