Troubleshooting
21
8. To switch off the product after sawing, press the on/off switch to stop continuous
operation. Then let go of the on/off switch.
The product will gradually come to a stop. Do not put down the product while it is
coming to a stop. Hold the product steady and wait until the saw blade comes to a
complete stop. Only then can you put the product down.
9. Pull the mains plug out of the socket to disconnect the product from the power
supply.
The workpiece is now sawn.
LED work light
The LED work light
6
lights up automatically as soon as the product is plugged into a
socket. It lights up for as long as the product is connected and goes out as soon as the
product is disconnected from the mains.
Troubleshooting
Problem Possible causes Solution
The product will
not start.
The mains plug has not been
inserted into a socket.
Insert the mains plug.
The fuse has triggered. Replace the fuse or switch it
back on (circuit breaker).
The saw blade de-
viates sideways.
Too much pressure is put on
the saw blade.
Reduce the pressure on the
saw blade.
The number of strokes used
is too high for the material
being cut.
Saw at a lower stroke rate.
The saw’s cutting
power is poor.
The saw blade
2
is blunt.
Have the saw blade sharpened
or replace it with a new one.
The saw blade is unsuitable
for the material being cut.
Use a saw blade suitable for the
material.
The cuts are
imprecise.
The saw blade is bent. Replace with a new saw blade.
The inserted saw
blade has come
loose.
The saw blade has not been
inserted correctly.
Insert the saw blade correctly.
The rotary toggle
5
has
not snapped back into the
locked position.
Reinsert the saw blade, making
sure that the rotary toggle en-
gages back in the locked position.
To Next Page
Loading...
Need help?
General
