Cleaning and maintenance
23
NOTICE!
Risk of damage!
Improper handling of the product can damage the product.
− Do not use water or chemical cleaning agents to clean the product.
− Do not use any aggressive cleaners, brushes with metal or nylon bristles,
or sharp or metallic cleaning utensils such as knives, hard scrapers, etc.
They could damage the surfaces.
− Do not grease the product. Dust and shavings can get stuck on a layer of
grease, increasing the wear on the product.
Cleaning
− Use a soft cloth or brush to clean the housing.
− Clean the ventsand the area around the saw blade holder
4
as well.
− Remove dust/shavings by blowing them out with compressed air.
Inspecting the product
Check the condition of the product regularly. Among other things, check to make sure:
− that the switches are not damaged,
− that the accessories are in proper condition,
− the vents are unobstructed and clean. If applicable, use a soft brush to clean
them.
− Check all connection points. These may be loosened over time due to vibration.
If you identify any damage, you must have it repaired by a specialist workshop
to prevent risks.
Maintenance
− Regularly lubricate all moving parts.
− Replace worn saw blades with new saw blades.
Storage
− Clean the product thoroughly prior to storage (see chapter “Cleaning”).
− If possible, store the clean product and the accessories in the original packaging.
− Store the product out of the reach of children in a dry, cool place.
To Next Page
Loading...
Need help?
General
