Objects that are picked up and flung around by the lawn mower
can also cause injuries.
- When adjusting the device, make sure that your fingers do
not get stuck between moving blades and stationary parts.
-
Do not open the safety flap if you are operating the device
without the grass collector.
Adjust cutting height
1. Ensure that the safety key
is removed.
2. Push the cutting height adjuster
towards the housing and set it to the
desired position.
Lift the lawnmower slightly if required to do so.
Position 1 is for short grass (25 mm), position 6 is for long grass (75 mm).
3. Push the cutting height adjuster outwards so that it locks into the required
position.
Switching on/off
1. Insert the safety key
into the opening provided until it locks in place.
2. Ensure that lawnmower is at a suitable location and that the cutting blades
cannot cause any injuries or damage.
3. To switch on the lawnmower, press and hold the safety button
.
Operation
17
To Next Page
Loading...
Need help?
General
