Use mulch kit
The mulch insert prevents the grass from being discharged to the rear by blocking
the collection chute. This results in the cut grass being distributed over the lawn
again during mowing.
1. Open the rear protective cover
, hold it in this position and slide the mulch
kit
into the rear discharge chute. Press down and latch (see Fig. 5).
2. Press the bottom part of the handle inwards to release and remove the mulch
kit.
Cleaning and maintenance
NOTE!
Risk of short circuit!
Water or other liquids that have penetrated the housing may
cause a short circuit.
- Never immerse the device in water or other liquids.
- Make sure that no water or other liquids penetrate the
housing.
NOTE!
Risk of damage!
Improper cleaning can damage the device.
- Do not use any aggressive cleaners, sharp or metallic cleaning
utensils such as knives, hard scrapers or similar items. These
could damage the surfaces.
Operation
19
To Next Page
Loading...
Need help?
General
