16
AFTER SALES SUPPORT
support@scheppach.com.au
1300 855 831
MODEL: HM80L PRODUCT CODE: 60120 04/2018
AUS Hotline Costs: Local rate for landline calls*
*Charges may vary dependent upon network operator or mobile network provider.
AUS
Safety regulations HM80L
10 Prior to the use of insertion tools, make sure that all protective devices are
properly fastened.
11 Prior to use, make sure that the insertion tool meets the technical require-
ments of this electric tool and is properly fastened.
12 Only use the supplied saw blade for sawing operations in wood.
Attention: Laser radiation
Do not stare into the beam
Class 2 laser
Protect yourself and you environment from accidents using suitable precau-
tionary measures!
• Do not look directly into the laser beam with unprotected eyes.
• Never look into the path of the beam.
• Never point the laser beam towards reecting surfaces and persons or animals.
Even a laser beam with a low output can cause damage to the eyes.
• Caution - methods other than those specied here can result in dangerous radi-
ation exposure.
• Never open the laser module. Unexpected exposure to the beam can occur.
• If the mitre saw is not used for an extended period of time, the batteries should
be removed.
• The laser may not be replaced with a different type of laser.
• Repairs of the laser may only be carried out by the laser manufacturer or an au-
thorised representative.
Safety instructions for handling batteries
1 Always make sure that the batteries are inserted with the correct polarity (+
and –), as indicated on the battery.
2 Do not short-circuit batteries.
3 Do not charge non-rechargeable batteries.
4 Do not overcharge batteries!
5 Do not mix old and new batteries or batteries of different types or manufacturers!
Replace an entire set of batteries at the same time.
6 Immediately remove used batteries from the device and dispose of them properly!
7 Do not allow batteries to heat up!
8 Do not weld or solder directly on batteries!
9 Do not dismantle batteries!
10 Do not allow batteries to deform!
To Next Page
Loading...
