AFTER SALES SUPPORT
17
1300 855 831
support@scheppach.com.au
AUS Hotline Costs: Local rate for landline calls*
*Charges may vary dependent upon network operator or mobile network provider.
MODEL: HM80L PRODUCT CODE: 60120 04/2018
AUS
HM80L Safety regulations
11 Do not throw batteries into re!
12 Keep batteries out of the reach of children.
13 Do not allow children to replace batteries without supervision!
14 Do not keep batteries near re, ovens or other sources of heat. Do not use
batteries in direct sunlight or store them in vehicles in hot weather.
15 Keep unused batteries in the original packaging and keep them away from metal
objects. Do not mix unpacked batteries or toss them together! This can lead
to a short-circuit of the battery and thus damage, burns or even the risk of re.
16 Remove batteries from the equipment when it will not be used for an extended
period of time, unless it is for emergencies!
17 NEVER handle batteries that have leaked without appropriate protection. If the
leaked uid comes into contact with your skin, the skin in this area should be
rinsed off under running water immediately. Always prevent the uid from com-
ing into contact with the eyes and mouth. In the event of contact, please seek
immediate medical attention.
18 Clean the battery contacts and corresponding contacts in the device prior to
inserting the batteries:
Residual risks
The machine has been built according to the state of the art and the recog-
nised technical safety requirements. However, individual residual risks can
arise during operation.
• Health hazard due to electrical power, with the use of improper electrical con-
nection cables.
• Furthermore, despite all precautions having been met, some non-obvious resid-
ual risks may still remain.
• Residual risks can be minimised if the "Safety regulations“ and the "Intended use“
are observed along with the whole of the operating instructions.
• Do not load the machine unnecessarily: excessive pressure when sawing will
quickly damage the saw blade, which results in reduced output of the machine in
the processing and in cut precision.
• When cutting plastic material, please always use clamps: the parts which should
be cut must always be xed between the clamps.
• Avoid accidental starting of the machine: the ON/OFF switch may not be pressed
when inserting the plug in an outlet.
• Use the tool that is recommended in this manual. In doing so, your mitre saw pro-
vides optimal performance.
• Hands may never enter the processing zone when the machine is in operation.
Release the ON/OFF switch and switch off the machine prior to any operations.
To Next Page
Loading...
