Alesis MMT-8 Instruction Manual

- Page 37 -
25 Memory
25.1 Remaining memory
Holding RECORD and pressing LENGTH causes the following display:
This shows the amount of memory that has not been used. Note that some operations may not be
possible even though it seems that there is still a small amount of memory available. This is due to the
fact that the MMT-8 requires enough memory to duplicate a part before it can be recorded on, or length
changed, or offset, etc. If a large part is attempted to be altered when there is not enough memory to
complete the operation, the display will indicate that there is not enough memory available to complete
the operation:
25.2 Clearing memory
To clear all of the MMT-8's memory and reinitialise all of its variables, turn power off, press and hold
ERASE, PAGE UP, and PAGE DOWN, and turn on the power while holding these buttons down for 3
seconds.

Alesis MMT-8 Specifications

General

Brand	Alesis
Model	MMT-8
Category	Recording Equipment
Language	English