64
Button Sewing
Unthread the needle thread.
Place a button on the fabric and lower the needle
by turning the handwheel, so that the needle
enters into the left hole in the button.
Align the holes in the button with the slot on the
foot and lower it to hold the button in place.
Turn the handwheel several times until the needle
bar swings to the right.
Adjust the stitch width so the needle enters into
the right hole in the button.
Rethread the machine and sew about 10 stitches
at a slow speed.
Raise the presser foot and remove the fabric.
Tr im both needle and bobbin threads at the
beginning.
Cut both threads leaving 8” (20 cm) tails.
Pull the bobbin thread to bring the needle thread to
the wrong side of the fabric then knot the threads.
After sewing is finished, raise the feed dog.
Machine Settings
q Pattern: #05
w Presser foot: Satin stitch foot F
e Thread tension: 3 – 7
r Feed dog: Lowered
q
w
e
r
To Next Page
Loading...
