AlgoForce E1500
19
The control box has a microphone that captures ambient
sounds, which can then be immediately played back through
the headphone. This feature allows the user to simultaneously
hear both the ambient sounds and detection audio. The Mic
Volume setting allows the user to adjust the volume of the
ambient sound playback. To use this feature, a headphone
must be connected.
Information about the power supply voltage, firmware version,
and hardware serial number can be found in the Miscellaneous
setting.
To perform a factory reset, hold both the Minus and Plus
buttons for 3 seconds. After a factory reset, the coil profiles,
including the coil names and calibration data, remain intact, so
you don't need to set up your coils again.
To Next Page
Loading...
