AlgoForce E1500
20
Software Upgrade Instruction
The AlgoForce E1500 and AlgoForce E1500 Plus share the same software binary file. However, it is
not recommended to use software versions earlier than V1.1.2 on the AlgoForce E1500 Plus.
Both models follow the same software upgrade procedure, which currently can only be performed
on a Windows operating system. Windows 10 or 11 are preferred.
To upgrade the software for free, follow these steps:
First-time upgrades: download the AlgoDownloader from
https://algoforce.com.au/pages/downloads.
Download the latest software binary file from
https://algoforce.com.au/pages/downloads.
Turn off the control box. Connect it to your PC with a USB cable.
Turn on the control box and it will automatically enter upgrade mode.
Open AlgoDownloader and choose the appropriate port from the dropdown list. The 'Filter'
option is selected by default, displaying only AlgoForce ports in the list. (Note: For Windows
7 and Windows 8, if the USB device driver is not already installed on your PC, the AlgoForce
port will not be displayed. In this case, download the USB device driver from
https://algoforce.com.au/pages/downloads and follow the instructions in the README.TXT
file included in the zip file to install it.) Click 'Browse' to select the downloaded firmware
binary file, and then click 'Update' to initiate the upgrade process (which takes
approximately 10 seconds).
Note: The port number may vary on different PCs. Incorrect port selection will result in an
upgrade error.
Once the upgrade is complete, a window will pop up displaying 'Upgrade Successful.' After
that, disconnect the control box from the PC.
Connect the power bank to the control box and turn it on. It is crucial to perform a factory
reset to fully complete the software upgrade process.
To Next Page
Loading...
