Alienware m17 P37E - Removing the Display Bezel; Prerequisites; Procedure

Removing the display bezel
WARNING: Before working inside your computer, read the safety information that shipped with your computer and
follow the steps in Before working inside your computer. After working inside your computer, follow the instructions
in
After working inside your computer. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
Prerequisites
1 Remove the base cover.
2 Remove the wireless card.
3 Remove the display assembly.
Procedure
NOTE: Ensure that the display assembly is placed on a clean and at surface.
1 Using a plastic scribe, unhook and release the sides of the display bezel from the display assembly as shown in the image in
the following order: Top (camera)->Left->Right->Bottom (Alienware logo).
NOTE: Note the location of each adhesive tape securing the display bezel to the display assembly (as shown in
yellow).
2 Lift the display bezel o the display assembly.
69