Align T-Rex 700 Nitro Pro - Main Frame Assembly Point

Main frame assembly point:
First do not fully tighten the screws of main frames
and put two bearings through the main shaft to
check if the movements are smooth. The bottom
bracket must be firmly touched the level table top
(glass surface); please keep the smooth movements
on main shaft and level bottom bracket, then slowly
tighten the screws. This assembly can help for the
power and flight performance.
i~H?iNHm.§:u
~~,(j :
n~.M~~~~ •• ,mA~•• g=•• ~~~k
~~~®mmE,~~~~®mfi*~~~®.~~
•••~:.~m~.mEfi~~~B~~.mm••
.M·ff~n~~~.~~~fimBttm~ ••• ~·
Glass surface
WWI;-'JZii3j
Main shaft
cum
_ Press two main frames equally.
-'JZf3T~~1IWmT~
Main frame
:HHIj~m
[ 700NB1A]
/
@~
'Apply a little amount of 143 thread
lock when fixing a metal part.
I!\!liiJli~D'-"1ffl!li"',"ffi'ffl~!I!T 43 (!'-!lii!!!)
...•.••..
Socket button head collillr screw
*~mH'JliJ3jflll~I:!;~(M3x8mm) x 2
CF Bottom bracket
!J!iiw![i;~
2.5mrn
. i
t:jlj
M3 Washer
M3Jj!D]
¢l3x¢8x1mm
Socket screw
"m!f'J7\!'JI:!;~
M3x12mm
M3 Set screw -----'
M3J.t;.'I!I:!;~ i
M3x4mm i
(
J>
r---,_
i
i
i
i
~-
M3 Set screw
M3J.t;.'I!I:!;~(M3x4mm) x 4
700NG1
@ m
M3 Washer
M3Jj!D]( ¢ 3x¢ 8x1mm) x 4
Skid pipe
W~~8g;
¢9x310mm
@ OnIIB~IIRil~JIII
Socket screw
rn!Im!f'J7\!'JI:!;~(M3x12mm) x 4
13