Alinco DJ-191 Quick Reference

CERT Communications Team Procedures
Alinco DJ-191 QUICK REFERENCE
Page 1
To: Do the following
Turn the radio on
Press the POWER key
Adjust the volume
Repeated press the UP or DOWN keys
Adjust the squelch
While holding the FUNCTION button, repeatedly
press either the UP or DOWN keys.
Set the frequency
1. If M or C is displayed, press the A key.
2. Using the keypad, enter all 6 digits of the desired
frequency
Change to Simplex
If a + or – is displayed, hold the FUNCTION button
and press the 2 key until they disappear.
Set offset for repeater
(duplex) operation
1. Hold the FUNCTION button and press the 2 key
until either a + (for positive offset) or a – (for
negative offset appears. Release the FUNCTION
button.
2. The offset frequency 0.60 should be displayed.
If it is not, or a different frequency is desired,
rotate the dial until the desired offset frequency
is displayed.
3. Briefly press PUSH TO TALK.
Set tone encode (PL)
1. Press and hold the FUNCTION button, then
press the 4 key until a T is displayed. Release the
FUNCTION key.
2. Rotate the dial until the desired tone frequency is
displayed.
3. Briefly press PUSH TO TALK.
Change power
Press and hold the FUNCTION button, then press
the LAMP H/L key. An L is displayed when the
radio is set to low power.

Alinco DJ-191 Specifications

General

Modulation	FM
Battery	Li-ion 7.4V 1800mAh
Waterproof	No
Type	Handheld
Power Output	5W
Dimensions	58 x 110 x 32 mm
Weight	220 g