To Next PageTo Next PageWhat to do if my Alinco DJ-A10 Transceiver has a green light but no sound?
If your Alinco Transceiver's receiving indicator shows a green light but you hear no sound, there might be a few reasons: * The volume could be set too low, so try increasing the audio level. * The volume switch or loudspeaker might be broken. In this case, contact local dealers to repair. * The earphone jack could be faulty. Contact local dealers to repair.
Why is my Alinco DJ-A10 receiving signal intermittent?
If the receiving signal on your Alinco Transceiver is intermittent, here's what you can check: * You might be out of communication range or obstructed by walls or buildings. Try changing your position to transmit. * Internal components may be in trouble, so please contact local dealers to repair.
Why does my Alinco DJ-A10 loudspeaker sound lower after usage?
If the loudspeaker of your Alinco Transceiver sounds lower or makes a dry noise after some time, it may be due to a broken loudspeaker or iron powder/dust inside the loudspeaker. In this case, please contact local dealers to repair.
General| Frequency Range | 136-174 MHz |
|---|---|
| Channels | 128 |
| Operating Voltage | 7.4V DC |
| IP Rating | IP54 |
| Mode | FM |
| Battery | Li-ion 7.4V 1500mAh |
| Number of Memory Channels | 128 |
| Channel Spacing | 12.5 kHz, 25 kHz |
| Output Power Options | High/Low |
Precautions and advice before operating the transceiver.
Safety advice concerning lightning when using the radio.
Information on the radio's dust and splash resistance.
Instructions to stay within FCC RF exposure limits.
How the transceiver interacts with other electronic devices.
Specific usage contexts and warnings for occupational use.
Warnings related to operating conditions and environment.
Guidelines for safe handling and operation of the transceiver.
Precautions and instructions for using the charger.
Procedures to follow in case of product malfunction or emergency.
Steps for attaching and detaching the battery pack.
Steps for attaching and detaching the antenna.
Steps for attaching and detaching the belt clip.
Explanation of the transceiver's LCD display icons.
Identification of front panel components and controls.
Identification of side panel components and ports.
How to turn the unit on/off and adjust audio level.
How to use the emergency alarm feature.
Switching between main channels and FM radio.
How to scan FM radio stations.
Steps for editing and deleting radio channels.
How to enable/disable the FM radio receiver.
How to enable or disable beep sounds.
Scanning for CTCSS/DCS tones.
General procedure for entering and navigating Set Mode.
Enabling or disabling voice guidance.
Setting transmission time limits.
Enabling voice-activated transmission.
Proper installation of earphone microphone.
Table of CTCSS frequencies.
Table of DCS codes.
