What to do if my Alinco Transceiver can not power on or frequently power off?
If your Alinco Transceiver isn't powering on, or frequently powers off, ensure that the battery pack is securely attached.
Why is my Alinco DJ-A40 Transceiver receiving indicator with green light but no sound?
If you can receive a signal with a green light on your Alinco Transceiver but hear no sound, first, increase the audio level to address the possibility of low volume. If the problem persists, it may indicate a broken volume switch, loudspeaker, or earphone jack, which requires inspection by local dealers.
Why I cannot talk or hear other members in my group with Alinco DJ-A40?
If you cannot talk to or hear other members in your group using the Alinco Transceiver, the issue might be due to different frequency or channel settings; if so, please change them. Alternatively, different CTCSS / DCS / DTMF settings could be the cause, so please reset them. It is also possible that you are simply out of communication range.
Why Alinco DJ-A40 communication distance becomes short, and has low sensitivity?
If your Alinco Transceiver's communication distance has become short, and sensitivity is low, check whether the antenna is in good conduction and the antenna base is not loose. The antenna may also be broken, and require service from your local dealer.
What to do if receiving signal is intermittent on Alinco DJ-A40?
If your Alinco Transceiver's receiving signal is intermittent, it could be because you are out of communication range or obstructed by walls or buildings. Try changing your position to transmit. It is also possible that internal components may be in trouble and need repair by local dealers.
How to fix no power on Alinco DJ-A40 Transceiver?
If your Alinco Transceiver has no power, the battery may be exhausting. Recharge or replace the battery. The battery may also not be installed correctly; remove the battery and install it again. If the power switch is broken or the battery life has ended, send it to local dealers to repair or contact them to replace the battery.
Why can I receive voice from the other parties but cannot transmit on my Alinco DJ-A40 Transceiver?
If you receive voice from other parties but cannot transmit on your Alinco Transceiver, it may be due to received interference or BCLO being activated.
What to do if Alinco DJ-A40 battery power dies shortly after charging?
If your Alinco Transceiver battery power dies shortly after charging, replace the battery pack with a new one.
Why Alinco DJ-A40 cannot scan?
If your Alinco Transceiver cannot scan, adjust the squelch level.
Why all band is noisy on Alinco DJ-A40 Transceiver?
If all bands are noisy on your Alinco Transceiver, adjust the squelch level.
General| Channel Capacity | 128 channels |
|---|---|
| Channel Spacing | 12.5/25 kHz |
| Waterproof | IP54 |
| Mode | FM |
| Output Power | 5 W |
| Battery Life | Approx. 12 hours |
| Operating Voltage | 7.4 V |
| Battery | 7.4V 1500mAh Li-ion |
| Modulation Type | 16K0F3E/11K0F3E |
To Next Page
