LARGE LIVE SETUP
The following diagrams illustrate how the icon can be used to drive additional amplifiers
where more loudspeakers and power are required. The L and R jack outputs can be plugged
into a graphic equaliser and amplifier to drive a front-of-house stereo speaker system while the
built-in amplifier is configured to provide two foldback monitors from the FB and AUX mixes.
Use the M (mono) jack output to drive a centre fill or sub-bass speaker system. A stereo
amplifier can be configured or linked so that the mono signal feeds both channels. The AB
SLAVE jack outputs can be used to drive additional amplifiers to supplement the built in amps.
These outputs are pre AB level but follow the AB graphic equalisers.
icon SERIES 6 - 3
To Next Page
Loading...
