ALLEN & HEATH iDR Series - iDR Monitor System Functionality

ALLEN&HEATH iDR training JAN08 Page - 11 - of 49
• Monitor system
Both the iDR-4 & iDR-8 have two balanced ¼” jack sockets for Monitor L & R IN and Monitor L & R
OUT.
The signal path can be monitored from:
Input channel
o Pre/post Delay
o Pre/post Parametric EQ
o Side Chain Filter
o Pre/post Gate/Comp
o Pre/post Fader
Output channel
o Pre/post Delay
o Pre/post Parametric EQ
o Pre/post Fader
o Pre/post Limiter
The monitor source can be selected in the System manager software or mapped to your computer
mouse. When mapped to the mouse, you can hold the mouse cursor over the part of the signal chain
that you want to listen to.
The monitor jack outputs can either feed local monitor amplifiers or connect to the monitor input jacks
on another iDR. This allows the monitor buses of several iDRs to ripple through.
The monitor jacks can be patched into the matrix giving a total i/o count of 10 x 10 for the iDR-8 and 6
x 6 for the iDR-4.