Allen & Heath User Guide for XONE:DX with Serato ITCH 1.6 52
RECORDING AND AUXILIARY INPUTS
RECORDING
ITCH can capture recordings of your mix output, mic, or aux input channels. Recording controls are
grouped into a strip below the Master Clock section. Select the source to record from the drop down
menu. The recording meter shows the signal level that will be recorded to disk. The Mix source records
the master output signal, post faders and EQ, pre master gain. Adjust the recording level using the con-
trols for the applicable source being recorded.
Click the REC button to start and stop recording. To save the recording to disk, type a filename into the
text field, and click SAVE. Recordings are saved in the recordings folder inside your main library folder.
If you forget to save a recording a temporary file will be saved to your Recordings Temp folder until you
record again.
NOTE: You can select the file format and bit depth for your recording in the playback tab of the setup
screen.
AUXILIARY INPUTS
The Allen & Heath Xone:DX features 4 stereo auxiliary inputs. They are as follows:
DECK 1 - LINE
DECK 2 - LINE / PHONO
DECK 3 - LINE / PHONO
DECK 4 - LINE / MIC
THRU MODE
Setting a channel to thru mode allows you to monitor and play an external source connected to the aux
inputs (e.g turntable / CD player etc).
To set a channel to thru mode, press SHIFT + CUE. When in THRU mode, the CUE LED will light up
orange.
When a channel is set to thru, the deck identifier will change to say 'thru', and if you have a track loaded
the waveform will turn grey.
To Next Page
Loading...
Need help?
General
