40 Rockwell Automation Publication 1791ES-UM001G-EN-P - November 2016
Chapter 3 Install the Module
For 1732ES Modules
ATTENTION: 1791ES modules are certified for use only within the
surrounding air temperature range of -20…+60 °C (-4…+140 °F). The
1791ES modules must not be used outside of this range.
WARNING: Do not replace components or disconnect equipment unless
power has been switched off or the area is known to be free of ignitable
concentrations.
This equipment is intended for use in overvoltage Category II applications (as
defined in IEC 60664-1), at altitudes up to 2000 m (6562 ft) without derating.
This equipment is not intended for use in residential environments and may not
provide adequate protection to radio communication services in such
environments.
This equipment is supplied as enclosed equipment. It should not require
additional system enclosure when used in locations consistent with the
enclosure type ratings stated in the Specifications section of this publication.
Subsequent sections of this publication may contain more information
regarding specific enclosure type ratings, beyond what this product provides,
that are required to comply with certain product safety certifications.
In addition to this publication, see the following:
• Industrial Automation Wiring and Grounding Guidelines,
publication 1770-4.1
, for more installation requirements.
• NEMA Standard 250 and EN/IEC 60529, as applicable, for explanations of the
degrees of protection provided by enclosures.
ATTENTION: All 1732ES modules EXCEPT the 1732ES-IB16 module are
certified for use only within the surrounding air temperature range of
-20…+55 °C (-4…+131 °F). All 1732ES modules EXCEPT the 1732ES-IB16
modules must not be used outside of this range. The 1732ES-IB16 module is
certified for use only within the surrounding air temperature range of
-20…+60 °C (-4…+140 °F). The 1732ES-IB16 module must not be used
outside of this range.
To Next Page
Loading...
