EasyManuals Logo

Allen-Bradley 1769-L33ER Quick Start

Allen-Bradley 1769-L33ER
88 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #50 background imageLoading...
Page #50 background image
50 Rockwell Automation Publication IASIMP-QS023B-EN-P - December 2012
Chapter 3 Configure the EtherNet/IP Network
Before You Begin
Before you begin, complete these tasks.
The tasks described in Chapter 1, Prepare the CompactLogix 5370 L3 Controller
Hardware on page 17, including:
Install the EtherNet/IP network
Install the controller and the local expansion module 1769-OB16 output module
Wire power to the controller
Make network connections
The tasks described inChapter 2, Prepare the Computer and Load Controller Firmware on
page 33
, including:
Install the Studio 5000 environment and RSLinx Classic software
Logix Designer application is installed when you install the Studio 5000 environment.
Configure an EtherNet/IP driver in RSLinx Classic software
Set the IP address for the computer
Load firmware on the controller
Verify that power is applied to all devices
IMPORTANT
If you connect all of the devices, including the computer, through an Ethernet switch, you can create an
isolated network. This chapter assumes you are using an isolated network. If you are not, contact your
network administrator to obtain IP addresses.

Table of Contents

Other manuals for Allen-Bradley 1769-L33ER

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Allen-Bradley 1769-L33ER and is the answer not in the manual?

Allen-Bradley 1769-L33ER Specifications

General IconGeneral
BrandAllen-Bradley
Model1769-L33ER
CategoryController
LanguageEnglish

Related product manuals