Installation Instructions
Original Instructions
CompactLogix 5480 Controller
Catalog Number
5069-L46ERMW
The CompactLogix™ 5480 controllers can operate in various applications, including the use of local Compact 5000™ I/O modules and
remote I/O modules and Integrated Motion over an EtherNet/IP network. The controllers offer the following:
• A Logix-based real-time controller that runs an instance of Windows 10 IoT Enterprise, also known as a commercial operating
system (COS)
• High-speed bus packet transfer rate
• High-speed I/O module communication, motion control, and use of Device Level Ring (DLR), Linear and Star EtherNet/IP topologies
• Multiple ports for use with the Logix control engine on the controller, including:
– One USB programming port for temporary connection
– Three Gigabit Ethernet ports for high-speed I/O communication and motion control
• Multiple ports for use with the COS on the controller, including:
– One Gigabit Ethernet port as a dedicated OS network interface
– An integrated DisplayPort for high definition monitor connectivity
– Two USB 3.0 ports for OS peripheral and expanded data storage capability
You use the Studio 5000 Logix Designer® application to configure CompactLogix 5480 controllers.
For more information on the components that are required to install a CompactLogix 5480 controller, see
page 5. For more information on how to
use the controller after you install it, see the publications that are listed in
Additional Resources on page 23.
Topic Page
About the Controller 4
Required System Components 5
Install the Controller onto the DIN Rail 8
Connect External Power Supplies to the Controller 8
Connect Control Signals Via UPS Control RTB 12
Install Compact 5000 I/O Modules 16
Install the End Cap 16
Power the System 16
Set the Network Internet Protocol (IP) Addresses 17
Connect the Controller to an EtherNet/IP Network 17
Remove and Replace the Controller 18
Replace the Fans 19
Specifications 22
Additional Resources 23
To Next Page
Need help?
General
