Allen-Bradley ControlLogix 1756-OF6VI - Wire the Module

8 ControlLogix Analog (10V) Output Module
Publication 1756-IN035C-EN-P - October 2000
Wire the Module
You can only connect wiring to your module through an RTB or IFM.
The example below shows how to wire the module.
After completing field-side wiring, secure the wires in the strain relief
area with a cable-tie.
20967-M
12
34
56
78
910
1112
1314
1516
1718
1920
+
–
Shield Ground
1756-OF6VI
OUT-1
Not used
RTN-1
OUT-3
RTN-3
Not used
OUT-5
Not used
Not used
RTN-5
OUT-0
Not used
RTN-0
OUT-2
RTN-2
Not used
OUT-4
Not used
Not used
RTN-4
User Analog
Output Device
NOTE: If separate power sources are used, do not exceed the specified isolation voltage.