18 ControlLogix Redundant Power Supply
Publication 1756-IN573C-EN-P - October 2003
Remove the Protective Label
Pull the label off the power supply.
Figure 18
Activate the Redundant Power Supply System
After you have installed the power supplies and connected them to the appropriate
chassis adapter module, flip the switch ON each supply to power the system.
Figure 19
ATTENTION
Make sure the power supply is mounted and all panel
fabrication is complete before you remove the protective label.
This label protects the power supply from metal shavings
falling inside the power supply.
42841
42666
I
POWER
0
To Next Page
Loading...
