Publication 1762-RM001C-EN-P
File Instructions 14-7
•
Bit Address - The source is the address of the bit to be transferred into
the bit array at the last (highest) bit position.
•
Length - The length operand contains the length of the bit array in
bits. The data range for length is from 0 to 2048.
Addressing Modes and File Types can be used as shown in the following
table:
Table 14.9 BSR Instruction Valid Addressing Modes and File Types
For definitions of the terms used in this table see Using the Instruction Descriptions on page4-2.
Parameter
Data Files Function Files
CS - Comms
IOS - I/O
Address
Mode
(1)
(1) See Important note about indirect addressing.
Address
Level
O
I
S
B
T, C, R
N
L
ST
MG, PD
RTC
HSC
PTO, PWM
STI
EII
BHI
MMI
DAT
TPI
Immediate
Direct
Indirect
Bit
Word
Long Word
Element
File •• • •• • •••
Control
(2)
(2) Control file only. Not valid for Timers and Counters.
• •
Length
• •
Source •• ••••
• ••
IMPORTANT
You cannot use indirect addressing with: S, ST, MG, PD,
RTC, HSC, PTO, PWM, STI, EII, BHI, MMI, DAT, TPI, CS,
IOS, and DLS files.
To Next Page
Loading...
