Publication 1762-RM001C-EN-P
File Instructions 14-13
Addressing Modes and File Types can be used as shown in the following
table:
Table 14.13 FFU Instruction Valid Addressing Modes and File Types
For definitions of the terms used in this table see Using the Instruction Descriptions on page4-2.
Parameter
Data Files Function Files
CS - Comms
IOS - I/O
Address
Mode
(1)
(1) See Important note about indirect addressing.
Address
Level
O
I
S
B
T, C, R
N
ST
L
MG, PD
RTC
HSC
PTO, PWM
STI
EII
BHI
MMI
DAT
TPI
Immediate
Direct
Indirect
Bit
Word
Long Word
Element
FIFO •• • • • • •••
Destination •• ••• •
• •••
Control
(2)
(2) Control file only. Not valid for Timers and Counters.
• •
Length
• •
Position
• •
IMPORTANT
You cannot use indirect addressing with: S, ST, MG, PD,
RTC, HSC, PTO, PWM, STI, EII, BHI, MMI, DAT, TPI, CS,
IOS, and DLS files.