50 Rockwell Automation Publication 2711R-UM001E-EN-E - January 2017
Chapter 2 Configuration Mode
2. Press Communication.
3. Press Port Settings.
4. The Ethernet and Serial ports are enabled by default. Press Enable for the
respective port to disable it, then press OK to confirm.
If the Ethernet port is disabled, you cannot set a static IP
address for the terminal. The terminal will prompt an alert (ID:
2058) when you try to do so.
Communication
Disable DHCP
Set Static IP Address
VNC Settings
Port Settings
Main
PV800T7T
0
Protocol: *
Status: Unavailable
Device Name:
Node Address:
IP Mode: DHCP
IP Address: 0.0.0.0
Mask: 0.0.0.0
Gateway: 0.0.0.0
MAC Address: XX:XX:XX:XX:XX
Port Settings
Enable
Enable
Back
Ethernet:
Serial:
To Next Page
Loading...
Need help?
General
