To Next PageTo Next PageWhat to do if Allen-Bradley I/O Systems are off?
If the Allen-Bradley I/O Systems are off, it could be due to several reasons. First, there might be no power applied to the device, in which case you should check the power supply. Alternatively, the device might not be online because it hasn't completed the duplicate MAC ID test or isn't powered. Check the module status indicator and power supply to resolve this.
Why is my Allen-Bradley I/O Systems showing a Red light?
A red light on your Allen-Bradley I/O Systems indicates an unrecoverable fault that may require device replacement. Consider replacing the device to resolve this issue.
What does flashing red mean on Allen-Bradley POINT I/O 1734-ADN?
A flashing red light on Allen-Bradley I/O Systems indicates a recoverable fault. Refer to the fault recovery procedures to troubleshoot and resolve the issue.
How to fix Allen-Bradley POINT I/O 1734-ADN flashing red/green?
If your Allen-Bradley I/O Systems are flashing red/green, it means the device has detected a network access error and is in a communication faulted state. To fix this, you need to address the network access error.
What to do if Allen-Bradley I/O Systems are flashing red?
If Allen-Bradley I/O Systems are flashing red, it means one or more I/O connections are in a timed-out state. You should investigate and resolve the I/O connection issues.
Why is Allen-Bradley POINT I/O 1734-ADN showing a solid red light?
A solid red light on Allen-Bradley I/O Systems indicates a critical link failure or a failed communication device. The device has detected an error preventing it from communicating on the network. Replace the failed communication device.
General| Catalog Number | 1734-ADN |
|---|---|
| Communication Protocol | DeviceNet |
| Power Supply | 24V DC |
| Environmental Rating | IP20 |
| Housing Material | Plastic |
| Product Type | Communication Adapter |
| Operating Temperature | 0 to 60 °C (32 to 140 °F) |
| Current Draw @ 24V DC | 0.1 A |
| Operating Voltage | 24V DC |
| Storage Temperature | -40°C to 85°C (-40°F to 185°F) |
| Relative Humidity | 5 to 95% (non-condensing) |
| Isolation Voltage | 50V DC continuous, verified with a 1500V AC dielectric withstand test for 1 min |
| DeviceNet Baud Rates | 125, 250, 500 kbps |
| Certifications | CE |
