Need help?Do you have a question about the Allen-Bradley POINT I/O and is the answer not in the manual?
General| Power Supply | 24V DC |
|---|---|
| Mounting | DIN Rail |
| Wiring Method | Removable terminal blocks |
| Communication Protocols | EtherNet/IP, DeviceNet, ControlNet |
| Operating Temperature Range | -20°C to 60°C (-4°F to 140°F) |
| Number of Channels | Varies by module (e.g., 8, 16, 32) |
| Certifications | CE, cUL |
| Type | Digital and Analog I/O Modules |
| Output Voltage | 24V DC |
Notes important considerations before using the adapter and warns about module compatibility.
Explains the procedure for configuring the chassis size for I/O connections.
Outlines requirements for configuring IP address, subnet mask, and gateway address.
Guides on using the BootP/DHCP utility for IP address configuration.
Warns about using DHCP and recommends fixed IP addresses for stability.
Details adding modules to the controller's I/O configuration.
Describes adding the POINT I/O adapter as a child of the Ethernet bridge.
Guides adding POINT I/O modules to the configuration list.
Details configuring a fixed IP address to maintain communication.
Describes setting up the I/O hardware for a ControlLogix system.
Details adding I/O modules to the controller I/O configuration.
Explains adding the EtherNet/IP bridge module to the I/O configuration.
Describes adding the I/O adapter as a child of the Ethernet bridge.
Guides adding POINT I/O modules and configuring rack-optimized connections.
Guides adding POINT I/O modules and configuring direct connections.
Provides steps to download the program to the ControlLogix controller.
Explains synchronizing chassis size from software to hardware.
Lists general specifications for POINT and ArmorPOINT I/O 2 Port EtherNet/IP Adapters.
Provides instructions for installing the RSLinx software.
Details configuring the AB_ETH Ethernet communication driver.
Explains how to configure the AB-ETHIP Ethernet communication driver.
To Next Page