Name: Allen-Bradley POINT I/O 1734-AENT
Brand: Allen-Bradley
Rating: 4 (1 reviews)

To Next Page

To Previous Page

POINT I/O EtherNet/IP Adapter 13

Publication 1734-IN042F-EN-P - November 2018

6. Slide the safety end cap up to remove it, which exposes the backplane and power

connections.

7. Position the replacement adapter vertically above the DIN rail, making certain

the DIN rail lock is in the horizontal position.

8. Slide the adapter down, allowing the interlocking side pieces to engage the

adjacent module.

9. Press firmly to seat the adapter on the DIN rail, noting that the adapter locking

mechanism will snap into place.

10. Set the node address on the Node Address pen push thumbwheel using a pen tip.

11. Insert the end of the terminal block opposite the handle into the base unit, noting

that this end has a curved section that engages with the wiring base.

12. Rotate the terminal block into the wiring base until it locks itself into place.

13. Replace the adjacent module in its base.

14. Reconnect the Ethernet cable(s) to the adapter.

15. Set the IP Address for this module.

16. Configure the adapter’s chassis size.

TIP

Press a pen tip into the center of the button cross, perpendicular to

the button. You only need a small amount of force to press the button

(approximately 2N).

Questions and Answers:

Need help?

Do you have a question about the Allen-Bradley POINT I/O 1734-AENT and is the answer not in the manual?

Allen-Bradley POINT I/O 1734-AENT Specifications

General