Allen-Bradley PowerFlex 70 Reference Manual

2-182 Start-Up
Figure 2.39 PowerFlex 70 & 700 Standard Control Option Startup
Basic Start Up (Top Level)
Main Menu:
<Diagnostics>
Parameter
Device Select
Memory Storage
StartUp
Preferences
No
PowerFlex 70
StartUp .
Complete these
steps in order:
1. Input Voltage
2. Motr Dat/Ramp
3. Motor Tests
4. Speed Limits
5. Speed Control
6. Strt,Stop,I/O
7. Done / Exit
0-0
PowerFlex 70
StartUp .
Make a selection
Abort
<Backup>
Resume
StartUp Menu
Resume
Startup Menu
0-3
HIM
7. Done
/Exit
Go to 2-0
Go to 4-0
Go to 5-0
2. Motor
Dat/Ramps
6. Strt,Stop,
I/O
4. Speed
Limits
Backup
'Esc' key
Go to 3-0
3. Motor
Tests
Go to 1-0
1. Input
Voltage
Go to 6-0
5. Speed
Control
PowerFlex 70
StartUp .
This routine is
to help setup a
drive for basic
applications.
Parameter access
through other
menus may be
necessary to
setup advanced
features.
0-1
PowerFlex 70
StartUp .
The drive must
be stopped to
proceed. Press
Esc to cancel.
0-2
Drive active?
Startup
Yes
Startup
previously
aborted?
No
Abort
Yes
Stop
Esc
Enter
Backup
Any state
Go to previous
state
Go to Backup
screen for previous
state

Allen-Bradley PowerFlex 70 Specifications

General

Input Voltage	200-240V AC, 380-480V AC, 500-600V AC
Frequency Range	0 - 400 Hz
Humidity	5% to 95% non-condensing
Output Voltage	0 to Input Voltage
Control Methods	Sensorless Vector Control
Communications	Ethernet/IP, DeviceNet, ControlNet
Protection Features	Overcurrent, Overvoltage, Undervoltage, Overtemperature, Ground Fault
Operating Temperature	0°C to 50°C (32°F to 122°F)
Storage Temperature	-40°C to 70°C (-40°F to 158°F)
Enclosure Rating	IP20, NEMA Type 1