Allen-Bradley Stratix 5200 1783-CMS20DN

To Next Page

Installation Instructions

Original Instructions

Stratix 5200 Ethernet Managed Switches

Catalog Numbers 1783-CMS6B, 1783-CMS6P, 1783-CMS10B, 1783-CMS10P, 1783-CMS10DP, 1783-CMS10DN, 1783-CMS20DB, 1783-CMS20DP, 1783-CMS20DN

Topic Page

Parts List 5

Required Tools 5

Site Requirements 5

Mount the Switch 6

Ground the Switch 7

Wire the DC Power Source 7

Install the Power Connectors on the Switch 8

Wire External Alarms 9

Connect to Console Ports 11

Install or Remove the SD Card 12

Install or Remove an SFP Module 12

Connect to 10/100 and 10/100/1000 Ports 13

Connect to 10Base-T, 100Base-TX, or 1000Base-T Ports 14

Connect to SFP Module Ports 13

Connect to a Dual-purpose Port 13

Confirm Installation 14

Remove the Switch from the DIN Rail 14

Specifications 15

Additional Resources 15

Need help?

Do you have a question about the Allen-Bradley Stratix 5200 1783-CMS20DN and is the answer not in the manual?

Summary

Parts List

Required Tools

Site Requirements

Mount the Switch

Ground the Switch

Wire the DC Power Source

Install the Power Connectors on the Switch

Wire External Alarms

Install the Alarm Relay Connector on the Switch

Connect to Console Ports

USB Micro-Type B Console Port

Connect the switch to a PC using a USB micro-Type B cable for console access.

RJ-45 Console Port

Connect the switch to a PC using an RJ-45 to DB-9 adapter cable for console access.

Install or Remove the SD Card

Install or Remove an SFP Module

Connect to SFP Module Ports

Connect to a Dual-purpose Port

Connect to 10;100 and 10;100;1000 Ports

Connect to 10 Base-T, 100 Base-TX, or 1000 Base-T Ports

Confirm Installation

Remove the Switch from the DIN Rail

Specifications

Rockwell Automation Support

Documentation Feedback

Provide feedback on the documentation to improve content and usability.

Waste Electrical and Electronic Equipment (WEEE)

Information on proper disposal of electronic equipment at the end of its lifecycle.