M411433 49
Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the tumbler before servicing.
• Close gas shut-off valve to gas tumbler before servicing.
• Close steam valve to steam tumbler before servicing.
• Never start the tumbler with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the tumbler is properly grounded.
W002
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
58. FRONT PANEL
a. Remove control panel.
b. Unlock, open and remove lint panel. Set aside
to prevent damage.
c. Open loading door, support door and remove
upper hinge bolt holding door to hinge bracket.
Refer to Figure 21.
NOTE: Nylon washer must be in place on lower
hinge pin when reinstalling door.
d. Remove door from bracket.
e. Support front panel and remove screws (and
three speed nuts) holding front panel to tumbler
cabinet. Refer to Figure 24.
NOTE: When removing front panel, lower panel
slightly to make sure door switch rod clears hole in
cabinet.
Figure 24
T032SE1D
FRONT PANEL
ATTACHING SCREWS
(13)
SPEED
NUTS
To Next Page
Loading...
