Programming NetMaster
F232152
102
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
101. Wash Extract Drain “+101”
This option allows the owner to program which drain
option will be used during Wash Extraction for all
cycles.
How to Program Wash Extract Drain
1. Control must be in Manual Mode. Refer to
Entering the Manual Mode.
2. Press the DELICATES (+) or the COLD (-)
keypad until “PrOg” appears in the VFD. Press
the START (enter) keypad and “+001” will
appear in the VFD.
Figure 168
3. Press the DELICATES (+) or the COLD (-)
keypad to scroll through the programmable
options until “+101” appears in the VFD. Refer
to Figure 169.
Figure 169
4. When “+101” appears in the VFD, press the
START (enter) keypad. The current drain output
value for the Wash Extract Drain will appear in
the VFD.
5. Press the DELICATES (+) or the COLD (-)
keypad to increase or decrease the current output
value displayed in the VFD to the desired output
value. Refer to Figure 170.
NOTE: Default output value is 002.
Figure 170
6. Press the START (enter) keypad when the correct
value appears in the VFD. The next option,
“+102”, will appear in the VFD.
NOTE: To program “+102” (Rinse #1 Fill/Tumble
Drain), refer to option 102. To program other
options, refer to the appropriate section.
How to Exit Programming Feature
1. Be sure the control shows a programmable option,
not a value.
2. While pressing and holding the NORMAL
keypad with one hand, press the PERM PRESS
keypad with the other hand. The control will
revert back to the Ready Mode.
C762I
COM144N
B029R
1 Press this pad (+) to scroll forward or increase a value
2 Press this pad (enter) to choose a selected value or
option
3 Press this pad (-) to scroll back or decrease a value
neednew#2
1
32
To Next Page
Loading...
