Alliance Laundry Systems NetMaster HC18NC2 - Permanent Press Extracts On;Off +059

Programming NetMaster
F232152
40
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
59. Permanent Press Extracts
On/Off “+059”
This option allows the owner to turn on and off
intermediate extractions during the Permanent Press
cycle.
How to Program Permanent Press
Extracts On/Off
1. Control must be in Manual Mode. Refer to
Entering the Manual Mode.
2. Press the DELICATES (+) or the COLD (-)
keypad until “PrOg” appears in the VFD. Press
the START (enter) keypad and “+001” will
appear in the VFD.
Figure 72
3. Press the DELICATES (+) or the COLD (-)
keypad to scroll through the programmable
options until “+059” appears in the VFD. Refer
to Figure 73.
Figure 73
4. When “+059” appears in the VFD, press the
START (enter) keypad. The current number set
for the Permanent Press Extracts On/Off will
appear in the VFD.
5. Press the DELICATES (+) or the COLD (-)
keypad to increase or decrease the current extract
value displayed in the VFD to the desired extract
value. Refer to Figure 74.
Figure 74
6. Press the START (enter) keypad when the correct
number of minutes appears in the VFD. The next
option, “+060”, will appear in the VFD.
NOTE: To program “+060” (Delicates PreWash #1
Fill/Tumble Time), refer to option 60. To program
other options, refer to the appropriate section.
How to Exit Programming Feature
1. Be sure the control shows a programmable option,
not a value.
2. While pressing and holding the NORMAL
keypad with one hand, press the PERM PRESS
keypad with the other hand. The control will
revert back to the Ready Mode.
C762I
C820I
C820I
B029R
1 Press this pad (+) to scroll forward or increase a value
2 Press this pad (enter) to choose a selected value or
option
3 Press this pad (-) to scroll back or decrease a value
neednew#2
1
32