Alliance Laundry Systems NetMaster HC18NC2 - Normal Extracts On;Off +050

Programming NetMaster
F232152
34
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
50. Normal Extracts On/Off “+050”
This option allows the owner to turn on and off
intermediate extractions during the Normal cycle.
How to Program Normal Extracts On/Off
1. Control must be in Manual Mode. Refer to
Entering the Manual Mode.
2. Press the DELICATES (+) or the COLD (-)
keypad until “PrOg” appears in the VFD. Press
the START (enter) keypad and “+001” will
appear in the VFD.
Figure 60
3. Press the DELICATES (+) or the COLD (-)
keypad to scroll through the programmable
options until “+050” appears in the VFD. Refer
to Figure 61.
Figure 61
4. When “+050” appears in the VFD, press the
START (enter) keypad. The current number set
for the Normal Extracts On/Off will appear in the
VFD.
5. Press the DELICATES (+) or the COLD (-)
keypad to increase or decrease the current extract
value displayed in the VFD to the desired extract
value as found in Table 2. Refer to Figure 62.
Figure 62
6. Press the START (enter) keypad when the correct
number of minutes appears in the VFD. The next
option, “+051”, will appear in the VFD.
NOTE: To program “+051” (Permanent Press
PreWash #1 Fill/Tumble Time), refer to option 51 in
Programming NetMaster in the Basic Programming
Guide. To program other options, refer to the
appropriate section.
How to Exit Programming Feature
1. Be sure the control shows a programmable option,
not a value.
2. While pressing and holding the NORMAL
keypad with one hand, press the PERM PRESS
keypad with the other hand. The control will
revert back to the Ready Mode.
C762I
C811I
C811I
B029R
1 Press this pad (+) to scroll forward or increase a value
2 Press this pad (enter) to choose a selected value or
option
3 Press this pad (-) to scroll back or decrease a value
neednew#2
1
32