Alliance Laundry Systems NetMaster HC18NC2 - Special Cycle Option +115

Programming NetMaster
129
F232152
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
115. Special Cycle Option “+115”
This option allows the owner to program the machine
to offer very high speed in final extract step and warm
water in final rinse step to customers for an added
vend price.
How to Program Special Cycle Option
1. Control must be in Manual Mode. Refer to
Entering the Manual Mode.
2. Press the DELICATES (+) or the COLD (-)
keypad until “PrOg” appears in the VFD. Press
the START (enter) keypad and “+001” will
appear in the VFD.
Figure 207
3. Press the DELICATES (+) or the COLD (-)
keypad to scroll through the programmable
options until “+115” appears in the VFD. Refer
to Figure 208.
Figure 208
4. When “+115” appears in the VFD, press the
START (enter) keypad. A number will appear in
the VFD. This number corresponds to the current
Special Cycle Option Programming Value.
5. Locate the desired number in the first column of
Table 41 on the following page.
6. Press the DELICATES (+) or the COLD (-)
keypad to increase or decrease the current
number until correct. Refer to Figure 209.
Figure 209
7. Press the START (enter) keypad when the correct
number appears in the VFD. The next option,
“+116”, will appear in the VFD.
NOTE: To program “+116” (Special Cycle Extra
Wash Fill/Agitate Time), refer to option 116. To
program other options, refer to the appropriate
section.
How to Exit Programming Feature
1. Be sure the control shows a programmable option,
not a value.
2. While pressing and holding the NORMAL
keypad with one hand, press the PERM PRESS
keypad with the other hand. The control will
revert back to the Ready Mode.
C762I
COM157N
COM157N
B029R
1 Press this pad (+) to scroll forward or increase a value
2 Press this pad (enter) to choose a selected value or
option
3 Press this pad (-) to scroll back or decrease a value
neednew#2
1
32