Programming NetMaster
29
F232152
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
34. Power Fail Reset “+034”
This option allows the owner to set the amount of time
NetMaster will store active cycle information in the
event of a power failure. The default settings for Power
Fail Reset are five minutes and turned “OFF.” If Power
Fail Reset is turned “OFF,” the cycle will be saved for
up to six years.
How to Program Power Fail Reset
1. Control must be in Manual Mode. Refer to
Entering the Manual Mode.
2. Press the DELICATES (+) or the COLD (-)
keypad until “PrOg” appears in the VFD. Press
the START (enter) keypad and “+001” will
appear in the VFD.
Figure 48
3. Press the DELICATES (+) or the COLD (-)
keypad to scroll through the programmable
options until “+034” appears in the VFD. Refer
to Figure 49.
Figure 49
4. When “+034” appears in the VFD, press the
START (enter) keypad. A number will appear in
the VFD. This number corresponds to the current
Power Fail Reset setting.
5. Press the DELICATES (+) or the COLD (-) keypad
to increase or decrease the current number to the
desired number selected from Table 1. Refer to
Figure 50.
Figure 50
6. Press the START (enter) keypad when the correct
number appears in the VFD. The next option,
“+035”, will appear in the VFD.
NOTE: To program “+035” (Set Real-Time Clock
Minutes), refer to option 35 in Programming
NetMaster in the Basic Programming Guide. To
program other options, refer to the appropriate
section.
How to Exit Programming Feature
1. Be sure the control shows a programmable option,
not a value.
2. While pressing and holding the NORMAL
keypad with one hand, press the PERM PRESS
keypad with the other hand. The control will
revert back to the Ready Mode.
C762I
C778I
C778I
B029R
1 Press this pad (+) to scroll forward or increase a value
2 Press this pad (enter) to choose a selected value or
option
3 Press this pad (-) to scroll back or decrease a value
neednew#2
1
32
To Next Page
Loading...
