To Next PageTo Next Page
Need help?Do you have a question about the Alliance Laundry Systems STB75CG and is the answer not in the manual?
General| Brand | Alliance Laundry Systems |
|---|---|
| Model | STB75CG |
| Category | Dryer |
| Capacity | 75 lb |
| Heating Method | Gas |
| Reversing Action | Yes |
| Drum Material | Stainless Steel |
| Type | Commercial |
| Control Type | Microprocessor |
| Phase | 3 |
Crucial safety precautions to prevent fire, shock, injury, or death.
Provides general information and lists tumbler models.
Illustrates where to find model and serial numbers on the tumbler.
Details on how to obtain literature or replacement parts.
Detailed physical dimensions and clearances for tumbler installation.
Specifies locations for exhaust connections for different tumbler models.
Specifies locations and sizes for gas supply connections.
Details locations for electrical service connections for various models.
Technical specifications for 30 lb, 28" wide gas and electric tumbler models.
Technical specifications for 30 lb gas, electric, and steam tumbler models.
Technical specifications for 50 lb gas and electric tumbler models.
Technical specifications for the 50 lb steam tumbler model.
Procedure for inspecting the tumbler for shipping damage upon delivery.
Lists materials needed for installation that must be locally sourced.
Instructions on how to move, position, and level the tumbler for installation.
Guidelines for building an enclosure around the tumbler, including clearances.
Specifies floor capacity, layout considerations, and make-up air needs.
Details on exhaust duct sizing, material, and routing for safety and efficiency.
Critical warnings, pressure requirements, and piping guidelines for gas connections.
Illustrates gas piping configurations for different tumbler capacities.
Guidelines for steam line sizing, trap installation, and insulation.
Procedures for connecting steam valves, traps, and return lines.
Essential steps for safely grounding the tumbler and electrical system.
Wiring requirements, breaker sizes, and wire gauges for various tumbler models.
Instructions for installing and removing timing cams on coin meter models.
Steps to verify tumbler components and systems before first use.
Verifying burner flame and air flow switch operation for gas/electric models.
Steps for setting controls and running a drying cycle on manual timer models.
Instructions for operating tumblers using coin slots or slides.
Procedure to adjust air shutter for optimal flame pattern and combustion.
Steps to adjust the air flow switch sensitivity for proper operation.
How to adjust the door switch and strike for proper door operation.
Instructions for adjusting belt tension on non-reversing and reversing models.
Step-by-step guide to operate the manual dual timer tumbler.
Instructions for operating coin-operated tumblers, including model variations.
Explanation of the reversing function and control switch operation.
Overview of OPL controls, cycles, and panel functions for automatic drying.
Details on setting fabric type, dryness, time, and creating custom cycles.
Daily procedure for cleaning the lint screen and compartment for optimal airflow.
Tasks for periodic maintenance, including lubrication, belt checks, and cleaning.
Solutions for common issues like tumbler not starting or not heating.
Addresses issues like air flow restriction, gas pressure, and voltage for proper operation.
