Allworx 9224 - 2 Adjusting the Phone; Base Assembly and Adjusting the Angle of the Phone; Update the PFK (Programmable Function Keys) Label

Phone Guide – 9224
Toll Free 1-866-ALLWORX • 585-421-3850 • www.allworx.com
Revised: April 16, 2013
Page 3
2 Adjusting the Phone
2.1 Base Assembly and Adjusting the Angle of the Phone
Users can adjust the Allworx phone base angle so that the Allworx Phone is
easy to use and read the screen while sitting on a desk.
To adjust the phone:
1. Remove the handset from the hook and lay the phone face down on a
soft surface with the top pointed away.
2. Hold the base with the fixed tabs facing the bottom of the phone.
3. Select one of the three available positions to connect the base to the
back of the phone. The nearest set of holes provides the steepest angle.
4. Place the fixed tabs in the preferred holes on the back of the phone.
5. Rotate the phone base towards the top until the flexible tabs click.
0.
To remove the base:
1. Remove the handset from the hook and lay the phone face down on a
soft surface with the top pointed away.
2. Press down on the flexible tabs and rotate the base towards the bottom
until the fixed tabs easily lift of the holes. 0.
2.2 Update the PFK (Programmable Function Keys) Label
Update the PFK labels whenever the PFK configuration changes to avoid
misdialing.
To add or change a label:
1. Locate the PFK label. Lift the bottom edge of the plastic cover to release
it, and then lift up on the plastic cover to remove it from the phone.
2. Remove the label from beneath the plastic label cover.
3. Add text on the label in the space corresponding to the desired PFK.
There is a blank label Microsoft Word™ template on the Allworx.com
website.