10
We reserve the right to modify technical specifications without prior notice.
UK830500/190402 © Alpha-InnoTec GmbH
Proceed as follows:
Remove packaging and set extra box aside (will be
needed later on!)…
Lift the unit from the pallet…
Remove front panel of unit…
t
To do so, loosen the quick-release screws. Turn
counter-clockwise 90°…
t
Lift front panel and set aside in a safe place…
Push hand truck under the unit (= rear side of unit).
CAUTION.
If the hand truck is pushed under the unit
on the back side of the unit, make sure not
to damage any connections during trans-
port.
CAUTION.
Transport with a hand truck on the front
side of the unit is not permitted.
DANGER!
The unit can tip when being removed from
the wooden pallet and during transport.
This can result in personal injury and
damage to the unit.
– Take suitable precautionary measures
to eliminate the danger of tipping.
DANGER!
Make sure to secure unit against slipping
during transport.
CAUTION.
Never use components and hydraulic
connections on the unit for purposes of
transport.
CAUTION.
Do not damage the hydraulic connections
under any circumstances.
CAUTION.
Do not tilt the unit more than a maximum
of 45° (in any direction).
To avoid damage during transport, you should transport
the unit to the final installation location in its original
packaging (with packaging on the wooden pallet), using
a lifting truck.
If it is not possible to transport the unit to the final
installation location using a lifting truck, you can also
transport the heat pump using a hand truck.
We recommend removing the front panel to reduce the
weight of the unit for further transport.
To Next Page
Loading...
Need help?
General
