21
We reserve the right to modify technical specifications without prior notice.
UK830500/190402 © Alpha-InnoTec GmbH
If this network cable is available, insert
the network cable’s RJ-45 plug into the
left bushing of the control element.
NOTICE.
The network cable can be exchanged at
any time. In order to be able to connect it,
the screen must rst be removed.
Installation and removal of the
screen
INSTALLING THE SCREEN
NOTICE.
The screen is provided at the time of
delivery so that the control element may
be inserted in the upper recesses of the
front facade.
If the control element has been inserted in
the lower recesses of the front facade, you
must rst remove the screen’s temporary
cover and then reinsert it above the logo.
Screen at time of delivery:
1 recess for control element
2 logo
3 temporary cover
First, insert the screen below, in the provided slots
on the front of the facade…
Beginning first on one side and moving upwards,
lock the screen’s snap-in lugs in place in the slots
provided on the front of the facade…
Next, on the opposite side, moving upwards.
Lock the screen’s snap-in lugs in place in the slots
provided on the front of the facade…
Finally, press the screen’s upper snap-in lugs into
the slots provided on the front of the facade.
REMOVING THE SCREEN
In order to remove the screen, the snap-in lugs must
rst be loosened by pressing one side completely
toward the middle of the screen. Thereafter, remove
the snap-in lugs from the opposite side.
To Next Page
Loading...
Need help?
General
