AlphaSmart 3000 63
SmartApplets can be installed only on the AlphaSmart 3000, and NOT on
the AlphaSmart Pro or AlphaSmart 2000.
How do I replace the Lithium battery?
1. Turn the AlphaSmart 3000 off.
2. Remove the 8 screws from the back using a Phillips screwdriver.
3. Flip the unit over and carefully open the case by lifting the front of
the top case, taking care not to disconnect the LCD cable.
4. With the unit open and the top case lying back, prevent static
discharge damage by touching one of the metal connector cubes on
the upper right side of the keyboard with your bare finger.
5. Locate the Lithium battery, which is a silver-colored coin cell
battery about the size of a nickel. The battery socket is found in the
upper-right corner of the printer circuit board.
6. Replace the Lithium battery. Make certain that the flat, plus (+) side
faces up. Slip the battery under the metal clip.
7. Close the lid. Replace the eight screws to the back. Confirm data is
saved by turning the AlphaSmart 3000 on (a “An unexpected Data
Change has occurred. Did you recently replace the lithium battery”
message should display). Type something in the file, and then turn
the AlphaSmart 3000 off and on again. At this point your entry
should still be visible, and you should no longer see the message.
How can I change the transfer speed?
When disconnected from the computer, press option-x-S and change the
speed as desired. For details, please see the section “Changing the Transfer
Speed.” For Macs, there is another option, TurboTransfer Software, which
speeds up the transfer speed by a factor of six. Please see the “TurboTransfer
Software” section on page 62 for more details.
AS3000UG.book Page 63 Tuesday, June 25, 2002 12:19 PM
To Next Page
Loading...
