2.18
ENG_UD68723_4
Frein de parking assisté (XEF - Alpine)
Brief stop
To apply the electronic parking brake
manually (when stopping at a red light,
or stopping when the engine is running,
etc.): pull and release the switch 2.
The brake is released as soon as the
vehicle is started up again.
Manual operation
You can control the electronic parking
brake manually.
Manually applying the electronic
parking brake
Pull switch 2. Warning light 3 and warn-
ing light
} on the instrument panel
light up.
Manually releasing the electronic
parking brake
With the ignition on, depress the brake
pedal then press switch 2: warning
light 3 and warning light
} go out.
1
3
2
The electronic parking
brake can be used to im-
mobilise the vehicle. Before
leaving the vehicle, check
that the electronic parking brake
is fully applied. Application of the
parking brake is confirmed by the
appearance of warning light 3 on
switch 2 and warning light
} on
the instrument panel until the doors
are locked. Depending on the vehi-
cle, a label may be located at the
top of the windscreen to remind you.
Special feature related to
the Stop and Start function:
if the driver's seat is unfas-
tened before the engine
goes into standby due to the Stop
and Start function, make sure that
the parking brake is applied: the
} indicator light on the instru-
ment panel confirms this. Risk of
loss of immobilisation.
ELECTRONIC PARKING BRAKE (2/4)
To Next Page
Loading...