Alpine A110 2021 - Levels (1;4)

brake fluid ..................................................
(current page)
levels:
brake fluid ............................................
(current page)
tanks and reservoirs
brake fluid ............................................
(current page)
4.10
ENG_UD51823_2
Niveau / Filtres (XEF - Alpine)
Levels
Brake fluid
 Brake fluid
The level should be read with the engine
switched off and on level ground.
This should be checked frequently,
and immediately if you notice even the
slightest loss in braking efficiency.
LEVELS (1/4)
3
Access
Depending on the vehicle, it may be
necessary to remove the scuttle panel
grille run channel to access the brake
fluid 3.
To do this:
– hold by the rear end the wing 4 of the
scuttle panel grille run channel 1 and
pull it upwards to unclip it from the
scuttle panel grille 2;
– take hold of the run channel on the
left-hand side then pull it upwards to-
wards you (movement B) to unclip it
fully;
1
B
C
– move to the left (movement C) to re-
lease the right-hand side of the run
channel and facilitate its movement
in relation to the strut;
– place the run channel 1 gently on a
clean and dry surface.
2
1
4
A
Vehicles not fitted with
storage compartment A
Due to the presence of me-
chanical components:
– it is forbidden to store objects
under the bonnet;
– when working on the engine
compartment, ensure that you do
not leave anything (cloths, tools,
etc.) Otherwise, this may lead
to the mechanical components
being damaged or cause a fire.
Risk of damage or fire;
– When working in the engine com-
partment, the mechanical com-
ponents may be hot. In addition,
the engine cooling fan may start
at any moment.
Risk of injury.
Before carrying out any
work under the bonnet, the
ignition must be switched
off (please see “Starting,
stopping the engine” in Section 2).