4.11
ENG_UD51823_2
Niveau / Filtres (XEF - Alpine)
LEVELS (2/4)
D
F
Refitting the scuttle panel grille run
channel
It is important to reposition the run
channel 1 correctly.
To do this:
– position the run channel 1 (move-
ment D);
– depending on the vehicle, insert the
run channel 1 into the wing cover
housing 7 (movement E);
– clip the component 6 on each end
of the run channel to the bodywork
mounting 5 (movement F);
– press the run channel (movement G)
to clip it.
Note: if you have difficulty clipping the
run channel 1 (movement G), check if
it has been inserted into components 5
and 7: risk of damage to run channel.
1
E
G
G
D
5
7
5
6
To Next Page
Loading...