Alpine A110 2021 - Changing a Wheel (1;2)

changing a wheel.......................................
(up to the end of the DU)
lifting the vehicle
changing a wheel .................................
(up to the end of the DU)
puncture.....................................................
(up to the end of the DU)
5.8
ENG_UD52294_2
Changement de roue (XEF - Alpine)
Continue to crank the jack so that the
baseplate is correctly positioned (it
should be underneath the vehicle and
aligned with the jack head).
Turn the wheelbrace until the wheel lifts
off the ground.
Changing a wheel
Switch on the hazard warn-
ing lights.
Keep the vehicle away from
traffic and on a level surface
where it will not slip.
Apply the parking brake and engage
P position (press and hold switch
N until the warning light integrated
in switch N appears in red) before
stopping the engine.
Ask all the passengers to leave the
vehicle and keep them away from
traffic.
CHANGING A WHEEL (1/2)
2
1
Vehicles equipped with a jack
and wheelbrace
For vehicles equipped with such,
remove the wheel bolt covers using the
pliers stored in the inflation kit casing.
Use the wheelbrace 1 to slacken off the
wheel bolts. Position it so as to be able
to push from above.
Crank up jack 2 by hand to position the
jack head against the jacking point clos-
est to the relevant wheel and marked
by an arrow 3.
If the vehicle is not equipped with
a jack, wheel wrench or other, a
tooling kit can be obtained from an
Approved Dealer.
3
If the vehicle is parked on
the hard shoulder, you must
warn other road users of
your vehicle’s presence
with a warning triangle or with other
devices as per the legislation apply-
ing to the country you are in.
To prevent any risk of injury
or damage to the vehicle,
only crank the jack until the
wheel you are replacing is
a maximum of three centimetres off
the ground.