2.27
ENG_UD59875_3
Avertisseur de perte de pression des pneumatiques (XEF - Alpine)
TYRE PRESSURE LOSS WARNING (2/3)
3
4
5
Resetting procedure
With the ignition on:
– briefly press button 4 or 5 to select
the journey parameters and use
button 2 to navigate to the “Tyre
pressure SET [Press-hold]” function
on the 3 display;
– press and hold (for around three sec-
onds) button 2, 4, or 5 to start initial-
isation. The message “Learning TP
initiated” is displayed for approxi-
mately five seconds. The request
to reset the reference tyre pressure
value has been taken into account.
Reinitialisation is carried out after a few
minutes’ driving.
Note: the value of the tyre pressure can
not be less than that recommended and
indicated on the edge of the driver’s
door or, depending on the vehicle, on
the bottom of the driver’s door.
Display
The display 3 on the instrument panel
informs you of any tyre pressure faults
(flat tyre, punctured tyre, etc.).
“Adjust tyre pressure”
Warning light
comes on, along
with the message “Adjust tyre pres-
sure”. This indicates that at least one
tyre is flat.
Check and, if necessary, readjust the
pressures of the four wheels when cold.
The warning light
goes off after a
few minutes’ driving.
“Puncture”
The warning light
comes on
steady, accompanied by the message
“Puncture” and a beep.
This message is accompanied by the
warning light
®.
They indicate that at least one wheel
is punctured or severely underinfla-
ted. Replace it or contact an authorised
dealer if it is punctured. Top up the tyre
pressure if the wheel is deflated.
Warning light ® re-
quires you to stop immedi-
ately, for your own safety,
as soon as traffic conditions
allow.
The sudden loss of pressure in a
tyre (burst tyre, etc.) cannot be de-
tected by the system.
2
To Next Page
Loading...